How do I fix a leaking hatch (and replace the rim with a new seal)?
How do I fix a leaking hatch (and replace the rim with a new seal)?
Replacing your hard plastic hatch rim on your kayak is relatively easy.
1. If the leak in your rim is small then try the following first with some silicon:
Tear off the removable glue/silicon of the hatch rim where it is leaking as best you can by hand.
Apply one full circle of glue to the hatch rim and screw parts, and especially a good amount where the leak is.
2. If the leak around your rim is large, then we recommend pulling it completely off and re-gluing and re-attaching it. In this video below we should you how to remove the hatch rim, clean it up and reinstall it with proper sealant so it will not leak anymore. You will need a multi-head screwdriver, a sharp knife and some good quality silicon. Please see instructions (download document at bottom of page) on a step by step guide to removing old rim and replacing it with a new one.
(Note: even though video shows a Riot brank kayak, the parts, and process of fixing the hatch rim remains the same on BorealDesign models)
Due to the flexing of the kayak both in transport and on the water, over time the foam wall separating the cockpit from the dry compartments (better known as a bulkhead) may come loose. The following video will show you how to inspect, prepare, fix ...
The first step to fixing a leak in your compartment/hatch is identifying where the water is entering. The possibilities are: The hatch cover is not forming an adequate seal, perhaps due to improper maintenance (requires regular cleanings to remove ...
Sometimes the rubber hatches are a bit difficult to put on the hatch rim. The fit is tight so that if forms a good seal to prevent water from entering the kayak. The best way is to: Start on one side pushing hatch down and running your hand along the ...
This article and attached file with video (see download link at the bottom of the page) walks you through the steps to replace and install new flanges to attach your kayak pedals to in a thermoformed ABS kayak for Boreal Design or Riot Kayaks. Tools ...
Here are the instructions for the Baffin P1 seat kit (BK002) or the Baffin P2/P3 Seat Kit (BK005), Replacing the seat is very simple. 1.- Remove the old kayak seat by removing the 2 screws on each side of the cockpit rim that hold the seat in place. ...