How to replace the hull support / water bottle holder on a BorealDesign thermoformed ABS kayak
Here are the necessary things to replace a broken support / bottle holder on a thermoformed ABS kayak.
Materials and Tools:
- a sharp utility knife
- small prybar
- sand paper
- gloves
- glue - we suggest a high quality plastic/metal adhesive which can be ordered from Amazon.
Steps:
- Remove old broken support / water bottle holder - carefully cutting and prying it loose
- Use sand paper to smooth and remove any of the residual glue on the hull
- Use sand paper to smooth the bottom of the support / water bottle holder
- Apply the ABS glue on the bottom of the support / water bottle holder around the edge and middle and install in place.
- Use tape to fasten both end of the support / water bottle holder so it stays in place while glue hardens.
Related Articles
How to repair and replace the rudder pedal support flanges on a thermoformed ABS kayak
This article and attached file with video (see download link at the bottom of the page) walks you through the steps to replace and install new flanges to attach your kayak pedals to in a thermoformed ABS kayak for Boreal Design or Riot Kayaks. Tools ...How to restore finish and colour to an ABS thermoformed plastic kayak
It is relatively simple to restore the finish to an ABS thermoformed kayak with the right acrylic lacquer spraypaint and a few simple tools/ materials needed. Download the following article (see bottom of page) for step by step instructions on how to ...How to repair or fix a cracked kayak
There is no reason why you cannot fix a plastic ABS Thermoformed or Composite boat on your own. Using these resources and the right tools it can be done. If it seems too difficult, then many kayak dealers and also marinas offer this service. Ask ...How to fix bulkheads on thermoformed ABS kayaks
If you are experiencing the issue of the bulkhead becoming separated or unglued on your Thermoformed ABS kayak, there is a relatively easy fix following these steps and with white Sikaflex marine caulking. See, download and print these instructions ...How do I fix a leaking hatch (and replace the rim with a new seal)?
Replacing your hard plastic hatch rim on your kayak is relatively easy. 1. If the leak in your rim is small then try the following first with some silicon: Tear off the removable glue/silicon of the hatch rim where it is leaking as best you can by ...