I am looking for the V-Block part that holds the rudder in place when not in use. This is for an Esperanto.

I am looking for the V-Block part that holds the rudder in place when not in use. This is for an Esperanto.

The  V-Block for the Esperanto can be purchased here


Assuming you have the bolts that hold on old one, you can re-use them. If not please just message me back when you place your order and will make sure we include the hardware.

Cheers

    • Related Articles

    • How to replace the hull support / water bottle holder on a BorealDesign thermoformed ABS kayak

      Here are the necessary things to replace a broken support / bottle holder on a thermoformed ABS kayak. Materials and Tools: a sharp utility knife small prybar sand paper gloves glue - we suggest a high quality plastic/metal adhesive which can be ...

    • How to install a kayak rudder support

      in this article and attached powerpoint slide set with videos we show you how to install the rudder support mount for your Boreal Design or Riot Kayak. See interactive powerpoint file attached that has videos embedded. Parts include 2 short ...

    • Looking for a BorealDesign kayak for two week trips in winter.

      Thanks for interest. I would suggest a few models for two trips any time of year including the winter. Epsilon Series (there are three sizes to fit different size paddlers and gear -( P100 to P300) - durable rotomolded polyethylene. USA: ...

    • How to secure the rudder for transport?

      We show you in this video how to use the bungee loop to secure your rudder in place when not in use or when transporting your kayak (so as not to damage your precious rudder). Use the pull tab on the bungee to loop it overtop of the rudder to secure ...

    • How do I install my rudder on a Boreal Design Kasko or Ookpik?

      If your rudder is not already installed on your Boreal Design Kasko or Ookpik kayak, here are the steps to to do this: Take out the long bolt and nut from the rudder wing assembly Assemble the rudder kit to fit the rudder support by installing the ...